Email:sales3@sukelaser.com Jinan Suke Science & Technology Co.,Ltd

Jinan Suke Science & Technology Co.,Ltd

Common problem of laser cutting machine

Common problem of laser machine

 Laser engraving machine 27.jpg

If the Boot but laser cutting machine is not start    
1.Check whether the machine electricity is ok
2.check the  main parameters  is correct  
Method:
1.check the electrical wires again
2.set up the parameters refer by software instructions
If Working without laser 
1.Check wether the optical path skewing
2.Line problem 
Method :
1.Adjust the light path
2.Judgment with plug the rays into the power of the signal terminal

 

The laser on and off at work    
1.Check whether the water cycle is ok 
2.whether the supply voltage is stabilize  
Method :                                                            
1.Clean the water tank and water pump,clear the pipe
2.Add voltage stabilize to power supply 
Theonline data can’t be disposed    
1.whether the communication cable is connected 
2.whether the software USB is  installed
Method
 :    
1.Shutdown and reconnect the cable
2.Reinstall the software and USB drive 

Processing size does not  consistent with software set 
1.Install the software
2.Adjust action    
Method:
1.install the original software torecover original parameters
2.sized the working area and trim size .calculate refer to software 


Related product: CNC laser engravig machine, laser engraving machine, laser engraver, laser cutter, CNC router, cutting plotter, plasma cutting machine, fiber laser marking machine, T shirter printer!!

Copyright © Jinan Suke Science & Technology Co.,Ltd All rights reserved.
QR Code